Multi-Capacitor PC Board

1 Review
SKU: PCB-TM-MULTICAP

Availability: Usually ships within 24 hours.

USD $‎9.95
Each
The Multi-Cap replacement PCB is intended to be a replacement for hard-to-find multi section capacitors used in vintage tube amplifiers. Note, the PCB is popped out of the surrounding board easily by twisting.

Requires capacitors with lead spacing of 5mm, and a maximum diameter of 13mm.

This DIY product is aimed towards the more experienced builder with a basic understanding of tube design.

Additional Information and Downloads

Downloads:
User Instructions (PDF)



Download Adobe Acrobat PDF reader


Warranty Information and Return Policy

Warranty Period: 3 months

All our tubes are guaranteed for 3 months from the date of purchase. (Any exceptions will be noted on that tube's Warranty tab)

If you receive a tube that does not perform to the manufacturer's specifications, please do the following:

- contact us to get a return authorization
- return it via regular mail within 90 days from when we shipped it, and we will provide an exchange or refund of the full purchase price of the tube.

Returns not related to warranty or defect will be considered at our discretion, and are subject to a 15% restocking fee.

We can not accept returns that don't have an authorization, are past 3 month, or are returned improperly.

These guidelines may be updated without notice.

Ratings & Reviews

1 review

  • 5 stars
  • 0 reviews
  • 4 stars
  • 0 reviews
  • 3 stars
  • 0 reviews
  • 1 star
  • 0 reviews

Backward Board Layout

by -

I purchased the Rev B version M2 Multicap board set to replace the multi-caps in a Model 528 amplifier in a 1953 Wurlitzer Jukebox. The chassis holes in the amp are somewhat octagonal, measuring 7/8-in wide across to opposite longer sides, and just shy of an inch across to the shorter (corner) sides. The Multicap board would have worked well, except it is backwards. The ground (negative) connections would be better placed around the outer edge of the board, with the positives on the inner circle, just as they are in a multi-cap. As it is, the chassis holes are too small to use these boards without some modification - i. e. cutting the connecting ground traces to enable the inner connections to be the positives.